Hi all!
Does anyone have a modification of the LCModel code to make it report the unsuppressed water intesity?
Or maybe just a tip which variable contains this value?
Thanks!
Andrei
Hi all!
Does anyone have a modification of the LCModel code to make it report the unsuppressed water intesity?
Or maybe just a tip which variable contains this value?
Thanks!
Andrei
Hi Andrei,
Yes, it’s a field called h2oarea
in the .print output file. You have to enable that output by adding LPRINT = 6
to your control file.
Cheers,
Georg
EDIT: The field is called Area of the unsuppressed water peak
, not h2oarea
- see below.
Thanks a lot, Georg!
I could not find it as the h2oarea
in the “print” file, but found the “Area of unsuppressed water peak”.
Best,
Andrei
You’re of course completely right - I had briefly searched our Osprey repository but didn’t peek far enough inside the print file reading function - sorry for that